Nightforce Wedge Prism Mount
Night Vision and Prism Mounting Measurement
Nightforce Wedge Prism Mount
Nightforce Wedge Prism Mount - No Rail

Night Vision & Prism Mount

F.A.S.T. Gen2 Chassis Night Vision Mount Kit. Compatible with NightForce Wedge Prism & TacomHQ Products.

Be sure to read this entire page (more information below) for important compatibility information.

Items included in the Kit:

  • One (1) Night Vision Mount in the width of your choice (1.5″, 1.75″, and 2.0″ available)
  • Two (2) M-LOK Adapter Plates
  • Four (4) M-LOK T-Nuts
  • Five (5) 10-32 x 3/8″ Button Head cap screws
  • Ten (10) 10-24 x 3/8″ Flathead screws
  • One (1) 1/8″ Hex Key (a.k.a. Allen Key)
  • One or more Picatinny rails (0, 25, 50,75, and 100 MOA available). Buy the Five Rails Kit and save up to $90.00.

 

 

Price range: $205.00 through $265.00

  • Total

UPC N/A SKUBXT-NVMount 5 Rail Kit 2.0 Categories, ,
Close
Product Specs
Mount Size

1.5" Wide Chassis, 1.75" Wide Chassis, 2" Wide Chassis, 2" Wide Chassis Tall, 2.25" Wide Chassis, Max Price, 2.5" Wide Chassis

These Night Vision Mounts may necessitate that the rifle scope sit higher than typical in relation to the barreled action. Therefore, you may need a higher scope base, higher scope rings (or mounts), or both. Consider this important information before ordering.

There are a small number of Mako, Baby Orca, and Mama Orca chassis that take 10-32 threads instead of 10-24, please carefully test the threads by hand before attempting installation. Both screws will be included with the kit.

Before ordering, please measure the width of your F.A.S.T. Chassis barrel channel. It should be 1,5″, 1.75″ or 2.0″. If you are obtaining different measurements, please email us pictures before ordering.

The following only applies to the G2 FAST Aluminum Chassis

The Mounts have White Laser Engravings indicating 1/4 inch larger than the intended chassis’ barrel channel width. For example, the Mount meant for 1.5″ barrel channels has an interior width and a corresponding engraving of “1.75 Inch”. This is to account for the M-LOK Adapter plates, which are 1/8″ thick each.

These Night Vision Mounts are designed for our Gen2 F.A.S.T. chassis, which have M-LOK ports along the barrel channel walls.

Gen1 F.A.S.T. Chassis do not have M-LOK ports and will not accept these Night Vision Mounts unless additional work is performed on them.*

*Your gunsmith may be able to drill and tap 10-32 holes in your Gen1 F.A.S.T. chassis, therefore allowing you to mount these Night Vision Mounts. If you are planning on conducting such work, contact us for instructions.

 

Related products